Reply To: BLER Curves

#4994
Markus Gasser
Participant

Hi Raydel,
The ability to plot the BLER curves should certainly not depend on the number of subframes simulated. Just executing simulation_results.plot_BLER_throughput after finishing simulating should work
If this howeever does not work, try this minimal working example and then adapt it to your desired simulation scenario:

  1. Open LTE_sim_batch and replace the line SNR_vec = 20; with SNR_vec = 0:20;
  2. Run the simulation LTE_sim_batch
  3. Plot the BLER curve

Best regards
Markus