Reply To: Beamforming Simulation never finishes

#9378
Tom Aird
Participant

Hi Fjolla,

Thank you for your advice, however I have attempted to set a break-point at “output_results_file = LTE_sim_main(LTE_config);” and the simulation never reaches the breakpoint. A results file is created, that keeps growing larger and larger, but the simulation never fully completes this line. If I manually end the simulation then the results file is not readable (matlab cannot open it – it says it is corrupted) so I cannot get any useful information from that.

Would it possible for you to run a simulation with the above parameters? I am simulating for only 10TTI and not a huge number of UEs so it really shouldn’t take that long to finish. I am capable of run multiple other simulation setups (including the beamforming demo) so it is not a problem with my installation/hardware.

Any help here would be greatly appreciated.

Tom