3D UMi

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #6517
    Naser
    Participant

    Dear Fjolla,

    In 3D model, how can we change the mode from UMa to UMi ?
    Is it only by directly changing the following parameters:

    1-LTE_config.inter_eNodeB_distance
    2-LTE_config.min_UE_eNodeB_distance
    3-LTE_config.tx_height
    4-LTE_config.eNodeB_tx_power

    or we need to change something else, so that the pathloss and shadow fading are calculated for UMi NOT for UMa.

    Thanks,
    Naser

    #6527

    Dear Naser,

    For changing between UMa and UMi scenarios, the relevant parameters should be changed. Except the ones you mentioned, also the pathloss type, shadow fading type and channel type given in +config\tri_sector_3D.m should be changed, then the correspondig parameters will be taken into account for the simulation.

    All parameters that are sceanrio specific are followed by a comment denoting that.

    Best regards,
    Fjolla

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.