SINR levels

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #7825
    Oscar
    Participant

    Dear moderators,

    When accessing the simulation_traces.UE_traces(nUE).SINR archive I can see that there’s an X number of arrays, corresponding to the number of TTIs used. Some of them are 1x1x32, and some are 1x1x34 arrays. When I open one of them, I can see that there are either 32 or 34 values stored. Could you please tell me what those values correspond to? I was thinking that I’d find the SINR level in dBs stored for each TTI in that archive, but I’m confused as to why there are so many values.

    Thank you for your time and attention.

    Best regards,
    Oscar

    #7908

    Dear Oscar,

    Could you specify the simulation parameters you used, I can not reproduce the same result.

    Thanks,
    Fjolla

    #7935
    Oscar
    Participant

    Dear Fjolla,

    Thanks for your response. I employed the following parameters:
    3D model; Frequency: 2GHz; BW: 10MHz; Tx mode: MU-MIMO 2×2; TTI: 11.

    You can see the results I’m talking about in images number 5 and 6. I’m confused as to why there are so many of them.
    https://www.dropbox.com/sh/31kznvt1daua61k/AADpudvpCQMQxCjZ914PGqcPa?dl=0

    Thank you so much for your attention.

    Best regards,
    Oscar

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.